When the wheel scrolls the wrong way
Why a scroll wheel jumps back now and then, how the test finds it, and what you can do.
What happens
The wheel tells the computer which way it turns by reading two signals in a set order. Dust or a worn part mixes up the order now and then, so a turn down sends a step up. Pages jump back while you read.
At first it is a small annoyance: a long page twitches up a line while you scroll down it. As the part wears, the jumps get bigger and more frequent, until scrolling a long document becomes a fight. The wheel still turns and still clicks; the fault is in the part that reads it, so nothing feels broken under your finger.
The same fault sometimes shows as a wheel that scrolls fine in one direction and badly in the other, or as a wheel that only works when turned slowly. All of them are the reader losing track of the order of its two signals.
How the test finds it
The scroll step asks for 3 seconds of scrolling down, then 3 seconds up. The page reads each wheel event with its direction and size, and works out which way you were going from the direction most events in the down phase had, so it does not matter which way your system calls down. Natural scrolling, which reverses the direction on purpose, is fine; the card only notes that the page scrolled toward the start.
Steps the other way in the middle of a phase are reversals; a run of them counts once. So a wheel that sends three wrong steps in a row, then carries on, has reversed once. The test counts the reversals in both phases together: one or two over the run is a warning, three or more fail.
Two things are left out on purpose. A free-spinning or smooth wheel keeps sending steps for a moment after you change direction, so opposite steps in the first second of a phase, before its first step in the right direction, are dropped as the previous phase's momentum. And on a trackpad, where a finger set down again wobbles, a run of opposite steps only counts when it adds up to 8 pixels or more.
Each phase needs at least 10 wheel events in its own direction to be judged; with fewer, the phase is not tested, and the card says which one. A wheel that only scrolls one way shows exactly that: a down phase with a result and an up phase that was never visited.
Pinch gestures, which arrive as wheel events with the control key, are ignored by this step, and sideways steps are counted as information.
What is normal
A healthy wheel produces no reversals in six seconds of scrolling. The card shows how many events it saw each way, which also tells you something: a wheel with notches sends one step per notch, while a smooth or hi-res wheel sends many small ones.
A single reversal that does not come back on a second run is more likely your finger changing direction for a moment than the wheel. A warning that returns on every run is the reader starting to wear. A fail is a wheel that is already hard to use, and it does not get better on its own.
If you use smooth scrolling in the browser or in the mouse's software, the page may see small opposite steps that are the smoothing, not the wheel. The lead-in rule catches most of them, but turn smoothing off and test again before you blame the hardware.
What to try
- Blow dust out around the wheel with short bursts of air while you turn it. Dust on the reader is the cheapest cause, and this fixes a surprising share of wheels.
- Turn off smooth scrolling in the browser or the mouse's software, and test again.
- Scroll at a steady, moderate pace during the step. Very fast flicks on a free-spinning wheel send a long tail of steps that can mask or mimic the fault.
- Try the mouse on another computer, or another port, to rule out the system. The wheel's reader is in the mouse, so a wheel that reverses everywhere is the mouse.
- If the wheel still jumps, the part that reads it is worn. A replacement or a repair service fixes it; the test's shareable report shows the counts.