Skip to content
BenchDevice

Keyboard tester

Does every key work?

Press every key on the drawing, then hold a few together. The test finds keys that don't register, register twice or stick.

Your keyboard

Press any key to see it light up.

How this test works

The page listens for key presses and releases and judges them here; nothing is sent anywhere. In step 1 you press every drawn key once. A key registers when the page sees its press and then its release. The same presses are judged for chatter, a key pressed again less than 30 ms after its own release, and for stuck keys, a key held 5000 ms or longer or still down when the step ends. In step 2 you hold three chords; the rollover test checks that every key of each chord registers together and that nothing else appears.

How to read the result

Each test gets a status and one measurement. Healthy means every test that ran passed. Needs attention means the keyboard still works: one chatter on a key, a key dropped while others were held, or fewer than 6 keys read at once. Faulty means a test failed: a key marked as not working, a key that chattered more than once, a key that stayed down, or a ghost key. Keys your system often keeps are optional and never block the run.

Common faults

A dead switch sends nothing, however you press the key. A chattering switch sends one press as two, so letters double. A stuck switch sends no release, so a letter repeats or a modifier stays on. A low rollover drops a key held with others; ghosting adds a key nobody pressed. Debris under a keycap can mimic any of these, so look there first.

What this test can't see

  • The Fn key and keys that switch the keyboard's own modes: they never leave the keyboard.
  • Shortcuts your system keeps, such as locking the screen or switching apps.
  • The keyboard's true polling rate and delay: the browser sees keys after your system does.
  • Debounce settings, how far a key travels before it registers, and the backlight.