Skip to content
BenchDevice

Mouse tester

Double clicks explained

Why a mouse clicks twice when you press once, how the test finds it, and what you can do.

What happens

A mouse button is a small switch. When it wears, its contacts bounce: one press reaches the computer as a press, a release and another press, a few milliseconds apart. You see a double click where you made one, or a drag that lets go on its own.

The fault is easy to miss at first. A file opens when you only meant to select it. A word gets picked when you wanted to place the cursor. A window you are dragging drops halfway across the screen. Each one looks like a slip of the hand, and the mouse works fine the rest of the day, so people live with it for months before they suspect the switch.

Switches wear with use, and the left button takes most of it. That is why a mouse often double clicks on the left while the right button stays perfect: the fault is in one switch, not in the mouse as a whole.

How the test finds it

The buttons step asks for 20 clicks with the left button, 20 with the right, and one press of every other button the mouse has. The page listens to each press and release and times the gap between them.

Every press of a button that comes less than 80 ms after that button's own release, with no movement between, counts as a double click. The movement rule matters: if the pointer moved to a new position between the release and the press, you made two clicks, and the test lets it be. A bounce happens with the mouse still.

Each button is judged on its own. One double click on a button is a warning; two or more on the same button fail the test. One double click on the left and one on the right is still a warning: the counts don't add up across buttons, because a worn switch is one switch.

A fast deliberate double click can come close to the limit, so click at a steady pace. The page shows your count as you go and tells you when a button has enough.

The result card lists the shortest gap it saw between a release and the next press of the same button. A healthy mouse shows a gap far above the limit, in the range of a human finger. A gap down near zero is the switch, not you.

What else the step reports

A few things the step notices are reported as information, without changing the result.

A button held for 2 seconds or longer, or still down when the step ends, is noted as held. That is usually a finger resting on the button; a button that holds itself down is caught in the rest step instead, where it fails as stuck.

A required button the test never saw, or a counted button with fewer than 20 clicks, makes the step not tested rather than failed. Run again and give each button its full count. If a button really does nothing, mark it as not working before the step, and the test fails it as dead instead of waiting for it.

Some browsers round their clock. When the clock is coarser than 10 ms, the page cannot tell a bounce from a quick second click, so it counts the clicks but does not judge double clicks, and says so. Another browser may give a finer clock.

What is normal

A mouse in good shape produces no double clicks across the whole step. A single one on a well-used mouse is worth a second run: repeat the step, and if it comes back clean, it was probably your finger. A warning that returns on every run is the switch starting to go, and it will get worse rather than better.

A fail is a worn switch. Nothing in software made the contacts bounce, and nothing in the test did either: the page only timed what the mouse sent.

What to try

All guidesBack to the mouse tester